Kosher Blog

Inexpensive, homemade PVC cheese press

There are a wide variety of tasty soft cheese that can be made without a cheese press, but, truth be told, those just aren’t as exciting (or delicious) as hard, aged cheeses. The only problem for the amateur cheesemaker is that retail cheese presses are, simply, expensive. New England Cheesemaking Supply’s top-of-the-line cheese press, while impressive, is $239. If you’ve never made a pressed cheese before, and you’re not sure if it’s your thing, the purchase of a good press can be quite a hinderance.

If you have $20 (maybe less) burning a hole in your pocket (and a few tools) you can put together a nifty, nice-looking press made out of PVC piping. My design (note: not yet field tested) is a bit different from most cheese presses out there, in that I use actual weights to press down the curds, rather than a spring-loaded setup with a pressure gauge. The basic premise: the base sits on a counter, supports a cheese mold (and drip pan if desired) and has vertical rods affixed to its four corners. A sliding platform runs along the vertical rods and, when loaded with weights (you know, the big round ones you see at the gym), it presses down on a follower into the curd-filled mold below.

You will need the following equipment:
• Hacksaw for cutting PVC piping
• PVC pipe primer and cement
• Coarse sandpaper
• Ruler/tape measure

You will need the following Schedule 40 PVC supplies (cost me all of $11.64 at Home Depot):
• 1 1-inch Cross
• 1 3/4-inch Cross
• 4 1-inch Tees
• 4 3/4-inch Tees
• 4 3/4-inch Caps
• 27″ 1-inch PVC pipe (minimum)
• 100″ 3/4-inch PVC pipe (minimum)

To use the press, you should also buy:
• Mold with follower
• Drip pan
• Something to sit between follower and bottom of sliding platform

With your hacksaw, cut the 1-inch pipe into four equal pieces (6 3/4″ each). Cut the 3/4-inch pipe into four 6 13/16″ pieces and four 18″ pieces, leaving a bit of pipe left over. Measure and cut carefully, but you needn’t be meticulous.

With your sandpaper, sand all pipe ends a bit to remove the prickly bits.

Insert the four 1-inch pipes snugly into the 1-inch cross, so you end up with a big X. Insert each of the four exposed ends into the perpendicular hole of a 1-inch tee so that you end up with the four open tubes which will slide up and down the base’s vertical poles.

With one “arm” connected

Fully assembled sliding platform

If you wish, prime and cement the pieces together for permanence.

Now, do the same with the 3/4-inch PVC pipes and fittings, but put the longer, 18″ pipes into the top of the tees, and put the caps on the bottom of the tees.

Fully assembled base, showing vertical pipes and bottom caps

Slide the platform onto the vertical rods, and there you have it.

Since I designed the press to be 1-foot square, I’ll probably cut notches into the corners of a heavy ceramic tile and lay it onto the base as a stable surface to hold a cheese mold. I’d also like to cut a hole into the sliding platform’s cross so I can insert a small piece of 1″ piping, which will anchor the round weights I intend to load on.